Loading... Please wait...

DIY Resole Footwear

Do you have a favorite pair of shoes or sandals that are in fine condition, feel great, but have worn out rubber soles? Don't throw them out - you can bring them back to life with our DIY Resole Kit. Below is a simple and affordable way to resole your favorite footwear. 


birkenstock-resole.jpg

 

Materials and Tools

birk-kit.jpg

 

Tools:

  • An old dull knife
  • Sand paper (Included in Kit)
  • Barge Glue  (Included in Kit)
  • Popsicle stick (Included in Kit)
  • Chalk (Included in Kit)
  • Box cutter


Materials:





Step 1: De-Soling

birk-old-sole.jpg

prying.jpg  prying-2.jpg  prying-3.jpg

sanding.jpg  sanded.jpg

1. This first step is important to do well, because any left over old sole material will make glueing on new sole more difficult. Normally the glue that shoe companies use on footwear is very strong so take your time removing it. Slowly work around the edges of the sole to pry and cut it free of your Birkenstock.

Tip: We suggest using an old kitchen knife or something that is strong enough to dive between the sole and Birkenstock and pry apart the bond. Once you remove the sole, sand off any remnant pieces of old rubber stuck on the Birkenstock. You will want a clean surface to glue your new sole to.

Important: Keep your old sole in tact to trace in the next step!




Step 2: Tracing and Cutting Out New Birkenstock Sole

tracing-birk.jpg

cutting-birk.jpg  trimming-birk.jpg  trimmed-birk.jpg

sanding-birk.jpg

1. Use the old sole you removed off your Birkenstock from Step 1.

2. Place it on a sheet of new Birkenstock sole material and trace with chalk. Use a sharp chalk edge to hug to the outline of old sole as closely as possible.

3. Find a piece of wood or cutting board to lay beneath the new Birkenstock sheet. Then use a box cutter and slowly cut out along chalk outline you created. Be sure to cut along the inside edge of the chalk line. 

4. Once cut, flip the sole over - traction side up. Go back to the heel area and smooth out rough edges with the the box cutter. Next use 120 grit sand paper to buff out the edges and make edges look clean.




Step 3: Glueing and Finishing

glue.jpg

spreading-glue.jpg  spread-glue.jpg  spread-glue-both.jpg

bonding.jpg  rubber-bands.jpg  finished-birk.jpg

1. Make sure both your old Birkenstock's and new soles are ready for glueing. Do a final sand-prep on both surfaces that will be glued together. This will create more surface area for your glue to bond.

2. Use Barge Cement and a popsicle stick to spread glue on both new sole cutout and your old Birkenstocks. Spread evenly and do not let puddle. Let glue dry (10-15 minutes). 

3. Re-apply a second layer of glue if some of it was absorbed into material surfaces. Wait and let dry again.

4. Bond your new sole to your Birkenstocks starting at the heel. The glue bonds quickly so there is little margin for error - be sure to line them up correctly!

5. Use strong rubber bands to keep the sole pressed up again the Birkenstock. Let dry for at least 12 hours.

6. Remove the rubber bands. If needed, sand out any glue on the edges of your rubber sole to make it look nice!


Email Alerts on Deals, Closeout Sales, New Products

Connect with us

FacebookTwitterPinterest